07-12-2006, 11:56 PM
Gasket matching you can do yuorself. Get everything lined up and etch the outline - get a set of rolls and go to town. Its hard to say if that's too thin - I'd say if it was somewhere close to an 1/8th it'd be enough lap there to catch everything good. As for polishing - on exhaust manifolds, it's hard to fuck up. If it's smooth, you're golden.
2013 Cadillac ATS....¶▅c●▄███████||▅▅▅▅▅▅▅▅▅▅▅▅▅▅▅▅||█~ ::~ :~ :►
2008 Chevy Malibu LT....▄██ ▲ █ █ ██▅▄▃▂
1986 Monte Carlo SS. ...███▲▲ █ █ ███████
1999 F250 SuperDuty...███████████████████►
1971 Monte Carlo SC ...◥☼▲⊙▲⊙▲⊙▲⊙▲⊙▲⊙▲⊙☼◤
2008 Chevy Malibu LT....▄██ ▲ █ █ ██▅▄▃▂
1986 Monte Carlo SS. ...███▲▲ █ █ ███████
1999 F250 SuperDuty...███████████████████►
1971 Monte Carlo SC ...◥☼▲⊙▲⊙▲⊙▲⊙▲⊙▲⊙▲⊙☼◤