Project C4, 85 Corvette

[Steve85]

I used a few fittings I had left over from the vacuum pump on the other engine.



Drilled another hole for an oil fill.



Rerouted the plug wires with some better looms. Not really huge difference, but it is to me.
Before:


After:


Power seat track out...


Manual track in.


Submarine belt wasmounted to the floor board and too far forward. So I made a bracket to bolt to the seat frame where it bolts to the rails. I use the same gauge steel as the seat frame and double the thickness where the bolt goes through because the hole had to be off-center.





finished product


I had to cut a slit in the seat cushion for the belt. I am really hoping to find a sleeve like a real seat has in that area.


Next project is a new wheel spacer for the right rear. It currently has a 5/16 but only needs an 1/8 just to give me a little breathing room to the suspension.

After that I just need to put some miles on it...