08-14-2008, 10:55 AM
Lots more stuff has been done... new wheel bearings, cleaned/greased the chassis bearings, flush the fluids. Nearly ready for the track :!:
Stock subframe installed and seat support "fabricated" ($10 Al flat stock from home depot, bench vice and a drill). Its more better.
![[Image: IMG_1118+_Large_.JPG]](http://boostrot.net/gallery/d/10209-1/IMG_1118+_Large_.JPG)
![[Image: IMG_1117+_Large_.JPG]](http://boostrot.net/gallery/d/10207-1/IMG_1117+_Large_.JPG)
![[Image: IMG_1116+_Large_.JPG]](http://boostrot.net/gallery/d/10205-1/IMG_1116+_Large_.JPG)
I picked up a spare set of carbs to set up with some different jetting - tearing carbs apart at the track is a horrible idea (IMO) so I picked up another set.
Seriously what could go wrong here :lol:
![[Image: IMG_1120+_Large_.JPG]](http://boostrot.net/gallery/d/10213-1/IMG_1120+_Large_.JPG)
![[Image: IMG_1121+_Large_.JPG]](http://boostrot.net/gallery/d/10215-1/IMG_1121+_Large_.JPG)
Measure your shims...
![[Image: IMG_1122+_Large_.JPG]](http://boostrot.net/gallery/d/10217-1/IMG_1122+_Large_.JPG)
Installed :thumbup:
![[Image: IMG_1124+_Large_.JPG]](http://boostrot.net/gallery/d/10221-1/IMG_1124+_Large_.JPG)
Stock subframe installed and seat support "fabricated" ($10 Al flat stock from home depot, bench vice and a drill). Its more better.
I picked up a spare set of carbs to set up with some different jetting - tearing carbs apart at the track is a horrible idea (IMO) so I picked up another set.
Seriously what could go wrong here :lol:
Measure your shims...
Installed :thumbup: