06-02-2008, 09:11 PM
.RJ Wrote:The master came from my F4i
Did you cut the front fender down too? Whys it only running on 3 cylinders?
I did cut the front fender down. I'm gonna use one of the pieces to make a little rear fender.
I'm not sure why it's only running on three. One of the carbs is flooding, i need to set the float heights. Where do you measure the float height? near the float valve? at the other end? in the middle? Resting on the tip of the float valve needle or with the spring depressed? I'm not sure. I need to do something about float bowl gaskets too.
I put in new plugs and set the gap. I set the points gap. I don't know where the timing mark is to check the timing, or to set static timing.
It seems like compression on one cylinder is low. I need to look at it some more though, it was near the end of the day today when I started troubleshooting in earnest.
horizontally opposed>*