Project Jon's Integra SE

[.RJ]

Busted Rear Mount, which I have a replacement for, but no place to do it at. Might just end up paying to have it replaced

Its not that hard to do in the parking lot - its not a very fun job and you'll invent new and interesting words but it can be done.

So far, I plan on doing some sort of brake upgrade.

For the HP the engine has, stock rotors/calipers are fine. If they're old, replace the lines and rebuild the calipers. Get some new rotors (autozone has some $13 rotors that work fine), fluid and good track friendly pads.

Suspension, I plan on purchasing some PIC Performance Coilovers

Once I get a place where I can actually work on my car I'd like to get all poly bushings and new control arms under the car.

You dont really need poly bushings, but they are cheap - the two things that usually need attention on these cars is the rear trailing arm bushings and front LCA bushings - they're probably torn and wasted by now.

For suspension... I'm going to pass along the and suggest Konis + GC coilovers. They're great shocks, great support, and reasonably priced - you can probably do the setup for < $900. Add in a stock ITR rear swaybar for cheap and the car will handle very well for a dancing elephant.

Good luck